Hello all!
Has anyone had any experience with deploying HP Thinpro 7, over the top of a Windows 10 installation, on a HP T630 Thin Client, using HPDM?
I was hoping I could capture the Thinpro image, and then use HPDM to deploy over the wire to Windows 10 T630 thin clients.
However what I have observed is that Thinpro get's inserted in to the smaller partition on the Win10 installation. So both operating systems are installed, although Thinpro is the one that boots. It just means that Thinpro doesn't get access to the whole system drive, not that it needs it, but I would prefer to have the whole disk available to Thinpro, and Win10 be completely overwritten.
Does anyone else have any experience of doing this?
Thanks in advance