Greetings,
recently acquired a used HD SAS Hotplug HD cage (466509-001) connected with a LSI HBA card. power up , disk spinning and properly shown up on Win 7 window explorer.
However, i did not see any working LED lights flashing on the HD trays. Check backside I notced there were some jumpers here and there, but i don't konw the defination. So if someone here who deal with this HD cage before and knowhow to place proper jumper(s), Please let me know so that LED working lights can be working again.
See attached jumper positions i found at the back side of the backplate. (note J12, J13 and I2C Conn, a 3 pin out connector)
Regards
PM100